Manhattan 525572 Range+ 1200AC Dual-Band Wireless Adapter - User Manual

MAN-525503/525534-UM-0413-01WIRELESS ACUSB ADAPTER USER MANUAL

10 4. If it’s an unnamed access point — that is, if the SSID (service set identication) of this wireless access point is hidden — you’ll be prompt

116. If you can see the screen below, the connection between your computer and wireless access point has been successfully established. Click Clos

122.1 GeneralThe initial utility screen that displays is General. As all the conguration screens do (Prole, Available Network, etc.), this screen

132.2 ProleThis section is for managing the networks you connect to frequently. Available Prole(s): This shows the preferred networks for the wire

14This is a computer-to-computer (ad hoc) network; wireless access points are not used: This option should not be activated in a standard home

15Data Encryption: Options are “WEP,” “TKIP” and “AES.” Select the correct value for the wireless network you wish to connect to. ASCII / Passp

16Available Network(s): This list shows all information of the available wireless networks within the range of your adapter (SSID, Channel, En

17stop reading this section now because everything that follows would not be applicable to your network. 2.5.1 PIN Input Cong (PIN) The rst method

184. Immediately after that, on the Manhattan wireless utility screen, click PIN Input Cong (PIN). You’ll be asked whether or not you want t

19 So, you may ask, if PBC involves pressing physical buttons, then why does the Manhattan wireless utility have an option for a push-button setup? Th

2 INTRODUCTIONThank you for purchasing this Manhattan™ Wireless AC USB Adapter. Because many netbooks and laptops (especially those more than a couple

202.6 Using the Wireless Adapter as an Access PointYour Manhattan wireless adapter supports three main operational modes: Station, Access Point and

21 Network Name (SSID): Every wireless network broadcasts an identication name, allowing wireless clients such as laptops, smartphones or tab

22Channel: Every wireless network operates on a specic channel. In the U.S., your wireless network can be set to channels 1–11; otherw

23The main conguration screen has two additional options as indicated by the red and blue arrows below. IP Address: This is the IP address which you

24 2.6.2 Virtual Wi-Fi ModeThe setup of Virtual Wi-Fi is nearly identical to that of Access Point mode. The main differences are that a) you activate

25

© IC Intracom. All rights reserved Manhattan is a trademark of IC Intracom, registered in the U.S. and other countries.

3 TABLE OF CONTENTS1 Initial Setup... 4 1.1 Insta

4 1 INITIAL SETUPThe following software installation procedure represents Windows 7. Instructions and screen images are similar for all current Windo

5 5. Click Next again to begin the installation of the driver and utility. A Setup Status screen (below) will display to indicate the progress of th

6 6. A warning about an unveried publisher or missing logo testing may display. Select “Install this driver software anyway” (or “Continue Anyway”

7 1.2 Connecting to a Wireless Access PointYou have two options for connecting to a wireless access point (AP): • To take advantage of all the extr

8 3. Input the security setting required for the wireless network you are trying to connect to and click OK to start the network connection.1.2.2

9 2. Click Connect to a network under “Network and Sharing Center.”3. Click the access point you want to use if it’s shown, then click Connect.